Electric Shutters Backup Power Pack Operation

(TORO System Only)                                V8-30-2006

Battery operation of the shutters in case of an electrical outage:

  • Unplug the power pack from the charger.
  • Slide open the covers on both ends before turning on the power.
  • Turn “ON” the Main Power Switch (single switch on back)
  • Remove the shutter cord from inside the end cover.
  • Plug the shutter cord (male 3 prongs) into the AC output socket onthe side of the Power Pack
  • Remove the slide protector from the wall receptacle
  • Move rocker switch to “TORO”
  • Plug the other end of the shutter cord (female IEC) into the shutterwall receptacle.
  • Now, operate the shutters as normal.

Use of the Light:

  • Unplug the power pack from the charger.
  • Slide open the covers on both ends before turning on the power.
  • Turn “ON” the Main Power Switch (single switch on back)
    • Switch UP: Light is “ON”
    • Switch MIDDLE: Light is “OFF”
    • Switch DOWN: Light is “FLASHING”

Charging the battery:

  • Assure the MAIN power switch is “OFF”
  • Insert the 12V input charging plug of the AC Power Charger into the12V input port of the battery
  • Plug the other end of the AC Power Charger cord into an AC wall outlet.
  • When not in use, keep the battery plugged in and charging at all times.

Checking the battery condition

  • Turn “ON” the AC Power Output Switch
  • When the “BATTERY LIGHT (Green) is “ON”, the battery is fully chargedand ready for use.
  • When the “BATTERY LIGHT (Green) is “OFF”, it means the Main Poweror the AC Power Switch is not switched “ON”. Or the battery has no power.Recharge the battery.
  • When the LOW BATTERY LIGHT (Green) is “FLASHING”, it means thebattery is low and needs to be recharged. When the light is not flashing, thebattery is fully charged.

IMPORTANT: It is recommended that the battery be used periodically each year by actually operating a couple of shutters each time with the battery.